Nielsen Sonic 35

Slim profile

This suppressor has a diameter of just 35 mm. Since smaller calibers do not need a large volume for optimal attenuation, you can settle for this small and slim suppressor. We recommend that this suppressor be used up to and including .243 Winchester.

Be aware that due to the very thin profile, a Sonic 35 can not go on pipes thicker than 20 mm.

The steel cores

The inside of the suppressor is steel, encapsulated in aluminum. This gives us the strength and durability against wear and tear, while the weight can be kept down. This is why we dare to give a 5 year total warranty for all suppressors purchased directly from us.

Caliber recommendation

When choosing your suppressor, it is important that you choose a suppressor that fits the caliber you are using. On the graphic you can see which calibers can be shot through the suppressor, as well as how well the amount of gunpowder can be handled by the suppressor.

Sonic 35 suppressor are primarily aimed at small calibers and calibers with relatively small charges.

Technical data

Dimensions

Weight: approx. 300 gram*
Diameter: 35 mm
Length: 250 mm
Extension of barrel: 125 mm
Max barrel thickness: 20 mm
*Weight may vary slightly depending on thread type.

Warranty

Warranty is according to local rules and is assumed by the dealer or distributor from whom it has been purchased. For any products purchased directly from us, we offer a 2-year warranty as described in our Terms & Conditions.

In Denmark we offer a full 5-year warranty, provided customers come to our manufacturing address with both rifle, ammunition and suppressor.

Maintenance

- - Avoid shooting the barrel too hot. Give the suppressor a light spray of WD40 or equivalent in the back end prior to mounting and after dismounting the suppressor. Particularly in humid weather.
  - Always allow the suppressor to dry-out thoroughly before placing it in storage.
  - Clean the suppressor as needed. Use only oil and cloth. A trip to the shooting range where the suppressor is shot medium heat is a good way to clear any excess gunpowder residue and soot.
  - Avoid the use of chemically basic cleaning agents, ultrasonic cleaners and brushes or scrubbing creams.
  - If the suppressor is to remain separable, it is recommended to regularly disassemble the suppressor and re-apply grease to the threads of the individual modules. Otherwise, modules will start to lock together over time. For our Sonic suppressors, this is not so much a problem due to the use of C-spanners. For all other suppressor, we offer a set of Tsom to aid in disassembly.